01
Blocked Drains & Sewer Backups
Water draining slowly, an overflowing gully or more than one blocked fixture can point to a restriction in the waste or sewer line. The cause might be built-up waste, roots, a damaged pipe or a local fixture blockage.
What we check: Which fixtures are affected, available access points and whether clearing, high-pressure jetting or a CCTV drain inspection is appropriate.
Blocked drain clearing →
02
Burst & Leaking Water Pipes
A burst pipe, sudden loss of pressure or water appearing where it should not can require prompt isolation. Repairs vary depending on the pipe material, its position and whether the damaged section is accessible.
What we check: The source and extent of the leak, accessible isolation points, pipe condition and the scope of replacement pipework needed.
Burst pipe repairs →
03
Hidden Water Leaks & Unexplained Usage
A rising water bill, damp wall, wet ground or a meter moving when no water is being used may indicate a concealed leak. The visible damp area is not always where the pipe is leaking.
What we check: Water-meter behaviour, affected fixtures, accessible water lines and whether further leak-location testing is justified.
Leak detection & water leak repairs →
04
Running, Leaking & Poorly Flushing Toilets
A toilet that continually refills, leaks onto the floor or does not flush properly may have a failed inlet valve, outlet seal, flush component or a drainage problem. The repair depends on the fault found.
What we check: The cistern and flush mechanism, visible seals and connections, and whether the problem is in the toilet or connected drainage.
Toilet repair options →
05
Dripping Taps & Leaking Mixers
A tap that drips after closing, leaks around its handle or is difficult to turn may need a washer, cartridge or other internal part. Sometimes replacing worn tapware is more practical than repairing it.
What we check: Tap or mixer type, access to isolation valves, cartridge compatibility and the condition of the fitting.
Tapware repairs →
06
Low Water Pressure & Poor Flow
Weak shower flow or low pressure at the kitchen sink can be caused by a blocked fitting, valve problem, supply restriction or pipework issue. A problem affecting one fixture differs from one affecting the whole property.
What we check: Which outlets are affected, measured pressure and flow where appropriate, isolation valves and accessible supply components.
Water pressure diagnosis →
Not Sure What Is Wrong? Book a Plumber.
If you cannot identify the problem, start with JR's $99 plumber call-out and initial visual inspection. Further diagnostics, labour, parts and materials are additional where required, subject to the selected service terms. If you already know the job, use the relevant service link above to review its own booking payment and pricing options.
Active leak? Turn off the property's main water supply if safe to do so, avoid wet electrical equipment and arrange assistance. Online availability does not guarantee immediate emergency attendance.